Advanced Technologies and Materials

Lorem ipsum dolor sit amet, consectetur adipisicing elit, sed do eiusmod tempor incididunt ut ero labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco.

Search
GUIDE FOR AUTHORS SUBMIT MANUSCRIPT
Vol. 49 No. 1 (2024)
Original articles

Effects of Aging and Refreshment Ratio on the Strength Properties of Selectively Laser Sintered Polyamide 12

Full text article (PDF)
  • Igor Drstvenšek,
  • Rembert Dhondt,
  • Snehashis Pal,
  • Tomaž Brajlih
Igor Drstvenšek
Faculty of Mechanical Engineering, University of Maribor, Smetanova ulica 17, 2000 Maribor, Slovenia
Rembert Dhondt
Jan De Nul nv, Tragel 60, 9308 Hofstade-Aalst, Belgium
Snehashis Pal
Faculty of Mechanical Engineering, University of Maribor, Smetanova ulica 17, 2000 Maribor, Slovenia
Tomaž Brajlih
Faculty of Mechanical Engineering, University of Maribor, Smetanova ulica 17, 2000 Maribor, Slovenia
DOI: https://doi.org/10.24867/ATM-2024-1-003

Published 2024-04-14

abstract views: 15 // Full text article (PDF): 3


Keywords

  • polyamide 12,
  • aging,
  • refresh ratio,
  • density,
  • tensile strength,
  • selective laser sintering
    • ...More
    Less

How to Cite

Drstvenšek, I., Dhondt, R., Pal, S., & Brajlih, T. (2024). Effects of Aging and Refreshment Ratio on the Strength Properties of Selectively Laser Sintered Polyamide 12. Advanced Technologies and Materials, 49(1), 19–23. https://doi.org/10.24867/ATM-2024-1-003

Copyright (c) 2024 Advanced Technologies and Materials

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Abstract

This study investigated how the tensile properties of selectively laser-sintered polyamide 12 (PA12) specimens are affected by aging and refresh ratio. Starting with a new powder, printing cycles of approximately ten hours were performed, during which tensile and density specimens were printed. After each cycle, the powder was tested for melt flow index (MFI). In the first part, the best processing direction was determined. It was found that tensile strength, modulus of elasticity, elongation at break and MFI showed a linear trend, with the independent variable being the number of hours at elevated temperature. This was analyzed by linear regression. MFI increased with the number of hours at elevated aging, while all other properties mentioned decreased.

PlumX Metrics

Dimensions Citation Metrics

Full text article (PDF)