Advanced Technologies and Materials

Lorem ipsum dolor sit amet, consectetur adipisicing elit, sed do eiusmod tempor incididunt ut ero labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco.

Search
GUIDE FOR AUTHORS SUBMIT MANUSCRIPT
Forthcoming
Original articles

Influence of Infill Density on the Mechanical Properties of FFF 3D-Printed PLA and PLA+CF Materials

Full text article
  • Gregor Horvat,
  • Izar Gaj Kek,
  • Boštjan Knap,
  • Marina Komočar,
  • Maja Okorn,
  • Elvis Hozdić
Gregor Horvat
University of Novo mesto, Faculty of Mechanical Engineering, Na Loko 2, SI-8000, Novo mesto, Slovenia
Izar Gaj Kek
University of Novo mesto, Faculty of Mechanical Engineering, Na Loko 2, SI-8000, Novo mesto, Slovenia
Boštjan Knap
University of Novo mesto, Faculty of Mechanical Engineering, Na Loko 2, SI-8000, Novo mesto, Slovenia
Marina Komočar
University of Novo mesto, Faculty of Mechanical Engineering, Na Loko 2, SI-8000, Novo mesto, Slovenia
Maja Okorn
University of Novo mesto, Faculty of Mechanical Engineering, Na Loko 2, SI-8000, Novo mesto, Slovenia
Elvis Hozdić
University of Novo mesto, Faculty of mechanical Engineering
DOI: https://doi.org/10.24867/ATM-2026-1-001

Published 2026-03-22

abstract views: 14 // Full text article: 0


Keywords

  • Additive manufacturing,
  • Fused Filament Fabrication,
  • density

How to Cite

Horvat, G., Kek, I. G., Knap, B., Komočar, M., Okorn, M., & Hozdić, E. (2026). Influence of Infill Density on the Mechanical Properties of FFF 3D-Printed PLA and PLA+CF Materials. Advanced Technologies and Materials, 1–12. https://doi.org/10.24867/ATM-2026-1-001

Copyright (c) 2026 Advanced Technologies and Materials

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Abstract

Fused Filament Fabrication (FFF) has become one of the most widely adopted additive manufacturing technologies for polymer-based components, particularly for polylactic acid (PLA) and carbon fiber–reinforced PLA (PLA+CF) materials. Among processing and structural parameters, infill density has been identified as a critical factor governing mechanical performance and environmental durability of printed parts. However, experimental findings reported in the literature remain fragmented and are often influenced by interacting process variables, limiting the direct transferability of results to engineering design.

This study presents a structured comparative synthesis and analytical review of previously published experimental datasets addressing the influence of infill density on tensile strength, elastic modulus, and failure behavior of FFF-printed PLA and PLA+CF materials. The analysis integrates results from three peer-reviewed studies, including data obtained under dry conditions and after controlled exposure to industrial lubricants. Density-dependent trends are systematically evaluated to identify consistent mechanical responses across different material systems and service environments.

The results demonstrate that increasing infill density generally improves tensile strength and stiffness due to reduced internal porosity and enhanced interlayer bonding. However, maximum load-bearing capacity does not always increase monotonically with densification, indicating the presence of optimal intermediate infill ranges. Environmental exposure is shown to cause density-dependent mechanical degradation, with higher infill densities providing improved resistance to lubricant penetration and stiffness loss. PLA+CF exhibits higher stiffness compared to neat PLA, while also showing increased sensitivity to brittle failure mechanisms.

The presented synthesis provides design-oriented insights into the role of infill density as a primary structural control parameter, supporting performance optimization of FFF-printed polymer components without modifications to material composition or processing hardware.

PlumX Metrics

Dimensions Citation Metrics

Full text article