Editorial
Published 2015-06-29
This work is licensed under a Creative Commons Attribution 4.0 International License.
Most read articles by the same author(s)
- Miroslav Plančak, Dejan Movrin, Igor Kačmarčik, Milentije Stefanović, Plavka Skakun, Dragiša Vilotić, Comparative analysis of classical forging and orbital forging of cross joint component , Advanced Technologies and Materials: Vol. 40 No. 2 (2015): Journal for Technology of Plasticity
- Milan Šljivić, Ranko Radonjić, Milentije Stefanović, Analysis of the hole flanging process , Advanced Technologies and Materials: Vol. 34 No. 1-2 (2009): Journal for Technology of Plasticity
- Srbislav Aleksandrovic, Milentije Stefanovic, Significance of strain path in conditions of variable blank holding force in deep drawing , Advanced Technologies and Materials: Vol. 30 No. 1-2 (2005): Journal for Technology of Plasticity
- Mladomir Milutinović, Miroslav Plančak, Dragiša Vilotić, Vesna Mandić, Milentije Stefanović, Influence of billet geometry on the process parameters in cold indenting , Advanced Technologies and Materials: Vol. 29 No. 1-2 (2004): Journal for Technology of Plasticity
- Milija Kraišnik, Dragiša Vilotić, Leposava Šiđanin, Milan Šljivić, Milentije Stefanović, Jovan Ilić, Analysis of microstructural damage on C45E steel in the process of cold upsetting of a cylinder , Advanced Technologies and Materials: Vol. 41 No. 1 (2016): Journal for Technology of Plasticity
- Milentije Stefanovic, Zvonko Gulisija, Branka Jordovic, Srbislav Aleksandrovic, Hot forging of high strength Al-alloys , Advanced Technologies and Materials: Vol. 32 No. 1-2 (2007): Journal for Technology of Plasticity
- Dragan Adamović, Milentije Stefanović, Vukić Lazić, Investigation of the influence of tool material and lubricant onto the process parameters and quality of work piece surface at ironing , Advanced Technologies and Materials: Vol. 28 No. 1-2 (2003): Journal for Technology of Plasticity
- Vesna Mandić, Milentije Stefanović, Physical modelling and FEM simulation of the hot bulk forming processes , Advanced Technologies and Materials: Vol. 27 No. 1-2 (2002): Journal for Technology of Plasticity
- Mladen Todić, Ostoja Miletić, Milentije Stefanović, Position of neutral areas of intensity of stress and deformations at two layer composite materials , Advanced Technologies and Materials: Vol. 30 No. 1-2 (2005): Journal for Technology of Plasticity