Advanced Technologies and Materials

Lorem ipsum dolor sit amet, consectetur adipisicing elit, sed do eiusmod tempor incididunt ut ero labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco.

GUIDE FOR AUTHORS SUBMIT MANUSCRIPT
Vol. 28 No. 1-2 (2003): Journal for Technology of Plasticity
Original articles

Correlation of die clearance value computed and experimentally determined during drawing of tinned sheet

Milan Dvořák
Technical University of Brno, Faculty of Mech. Engineering Institute of Technology, Dept. of Forming, Czech republi

Published 2003-12-26

abstract views: 10 // Full text article (PDF): 5


How to Cite

Dvořák, M. (2003). Correlation of die clearance value computed and experimentally determined during drawing of tinned sheet. Advanced Technologies and Materials, 28(1-2), 65–72. Retrieved from https://jged.uns.ac.rs/index.php/atm/article/view/jtp.2003.28.1-2.7

Abstract

The aim of this study is calculation of die clearance from literature data followed by experimental verification on steel sheets. Steel sheet, thickness 0.24 mm. electroplated on both sides by tin with surface density 5.6/5.6 gm-2 was selected. For experiments the drawing die was developed on TU of Brno. The uniformity of wall thickness of cylindrical shells without flange was measured on lines oriented 0°, 45°, and 90° with respect to the drawing direction. The results could be utilized in press shops.

PlumX Metrics

Dimensions Citation Metrics