Advanced Technologies and Materials

Lorem ipsum dolor sit amet, consectetur adipisicing elit, sed do eiusmod tempor incididunt ut ero labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco.

GUIDE FOR AUTHORS SUBMIT MANUSCRIPT
Vol. 40 No. 2 (2015): Journal for Technology of Plasticity
Original articles

Risk assessment in injection molding process

Saša Ranđelović
University of Niš, Faculty of Mechanical Engineering, Serbia
Mladomir Milutinović
University of Novi Sad, Faculty of Technical Sciences, Novi Sad, Serbia
Saša Nikolić
University of Niš, Faculty of Mechanical Engineering, Serbia
Igor Kačmarčik
University of Novi Sad, Faculty of Technical Sciences, Novi Sad, Serbia

Published 2015-12-21

abstract views: 40 // Full text article (PDF): 0


Keywords

  • FMEA,
  • FEM,
  • injection molding,
  • pipe fittings

How to Cite

Ranđelović, S., Milutinović, M., Nikolić, S., & Kačmarčik, I. (2015). Risk assessment in injection molding process. Advanced Technologies and Materials, 40(2), 23–34. Retrieved from https://jged.uns.ac.rs/index.php/atm/article/view/JTP.2015.40.2.3

Abstract

Failure modes and effects analysis is one of the most important methods for determining reliability of the whole production system. If this analysis is implemented in the early stage of a process development, many problems and part errors can be reduced. This is essential nowadays, since high competitive markets force manufacturers to produce high quality products as cheap as possible.

In this paper FMEA was performed in case of injection molding process for manufacturing pipe fittings Ø75/45° and Ø75/90°, using results obtained from both numerical simulation (MOLDEX3D) and the experiment.

PlumX Metrics

Dimensions Citation Metrics